|
To make slip tip:
Rear section:
cut a 3" section of stainless steel
drill centering hole in end
drill side I hold 7/8" deep for threads
drill 21/64 hole 1/4 for shaft shoulder
Tap 5/16 - 24 to bottom of thread hole
Front section:
cut a 2" section of stainless steel
drill centering hole in end
Drill XXX into end YYY deep for cable hole
cut XXX long yyy diameter for threads
Die threads onto end
machine cut on side (with 1/8 key cutter) into cable hole
End-Tip:
cut a 1.5" section of stainless steel
drill and thread rear end with 5/16 - 24 threads
machine tri tip or pencil point onto front end
Cable:
Swage crimp onto 3/32 cable end
Insert through slip tip from front
Insert cable through slide ring appropriate for shaft diameter
Swage crimp onto cable below slide ring
To make the adaptor:
cut .7 long .31 diameter
cut .4 long .235 diameter
cut ball to .205 diameter
cut angle behind ball
clean up and hand polish to get perfect fit into slip tip
drill and thread rear end with 5/16 - 24 threads
